[Previous Message]
[Next Message]
|
| Date: |
May 02, 2005 at 16:27:49 |
| From: |
Dave, [lon53-uas-2-209197133168.3web.net] |
| Subject: |
Car Subwoofer instalation? |
|
|
|
|
I have an 86 RX-7 and am currently planing a subwoofer box for it i am using 2 15"
Pyramid Subs with
* Power handling: 300 watts RMS/600 watts max
* Voice coil diameter: 2"
* Impedance: 4 ohms
* Re: 3.24 ohms
* Frequency response: 30-1,000 Hz
* Magnet weight: 100 oz.
* Fs: 30.0 Hz
* SPL: 92.7 dB 2.83V/1m
* Vas: 3.97 cu. ft.
* Qms: 4.57
* Qes: .64
* Qts: .56
. This car comes stock with 2 storage compartments that are about 18x32x28 each. The area which has the 2 storage compartments is permanent but could be completly removed(with a large amount of effort). I was just wondering if I should use the storage tubs as 2 seperate enclosures or weather i shold remove that area completly and build an enclosure using the whole area?? The area which houses the tubs spans the whole width of the car and is about 4" deaper than the tubs themselves. And if I should remove that area and make my own enclosures should the area be divided in half 1 half for each sub or should they share the entire enclosure??
I would apreciate any opinions.
Thanks.
|
|
|
| View entire thread |
Posted with TalkShop version
2.76 BETA |
[Previous Message]
[Next Message]
|
|
|
Follow Ups: |
|
|
|
[
The Subwoofer DIY Page - Discussion Forum ] [ FAQ ] |
|
