Internal Bracing Questions

The Subwoofer DIY Page - Discussion Forum

[ The Subwoofer DIY Page - Discussion Forum ] [ FAQ ]

Date: July 23, 2003 at 11:04:54
From: Jordan, [216-237-196-136-dslam1-hmc.northstate.net]
Subject: Internal Bracing Questions

Somewhere in the DIYSubwoofers.org page it says internal bracing should be asymmetric. Why is this? Wouldn't that be less geometrically strong than symmetrical braces?
Should I make bracing as strong as possible? Or should I just put some minimal bracing where the brace (I’m using 1" square cuts of MDF) always contacts two walls of the box that have a joint. (EG: no opposite end panels have the same brace)
What would be the advantages or disadvantages of different internal bracing methods?

If necessary, I’m building a 2.1 cu. foot sealed enclosure for a tumult driver for my car. (QTC around .68-.7, planning on stuffing it)
http://www.adireaudio.com/diy_audio/drivers/adire/tumult.htm

View entire thread

Posted with TalkShop version 2.74

[Previous Message] [Next Message]

Follow Ups:

Re: Internal Bracing Questions Brian Owens 23-Jul-2003 13:46:30 (6)

Re: Internal Bracing Questions Jordan 23-Jul-2003 22:31:05 (1)

Re: Internal Bracing Questions Brian Owens 24-Jul-2003 13:01:39 (0)

Re: Internal Bracing Questions Derek 23-Jul-2003 15:32:35 (3)

Re: Internal Bracing Questions Brian 26-Jul-2003 19:00:04 (0)

Re: Internal Bracing Questions Brian Owens 23-Jul-2003 16:29:59 (1)

Re: Internal Bracing Questions Derek 24-Jul-2003 00:46:26 (0)

[ The Subwoofer DIY Page - Discussion Forum ] [ FAQ ]