The Subwoofer DIY Page - Discussion Forum

[ The Subwoofer DIY Page - Discussion Forum ] [ FAQ ]

[Previous Message] [Next Message]

Date: July 28, 2002 at 19:25:53
From: Adrian Mack, [dialup-196-83.wasp.net.au]
Subject: Re: 2 1203's for my 6500d?

URL: My Peerless XLS Dual Passive Radiator subwoofer project


"this is such a dumb question but how do u wire it in parellel? and is it possible that it isnt in parallel right now with the one driver i have?"

No, its not wired in parallel at the moment, as you only have one 1203. Two drivers are required to wire in parallel. For parallel connection for a 2ohm load total on the two 1203's, you must wire the positive terminals on each driver togethor, and the negative terminals on each driver togethor. Then, a wire going from the outputs of the amp to one of the drivers. This will present a 2 ohm load.

The Audio Source 15" subwoofer you mentioned is a home theatre subwoofer, and is already in its own box with powered amp (assumingly). I would not reccomend it for the car. You wont need it anyway: two BPD1203's is enough, and you wont have enough power for the 15"er anyway.


  • View the previous message in this thread
  • Go to the top of this thread
  • View entire thread
    		•

    Posted with TalkShop version 2.73

    [Previous Message] [Next Message]



    Follow Ups:

    [ The Subwoofer DIY Page - Discussion Forum ] [ FAQ ]