The Subwoofer DIY Page - Discussion Forum

[ The Subwoofer DIY Page - Discussion Forum ] [ FAQ ]

[Previous Message] [Next Message]

Date: March 30, 2002 at 23:21:59
From: Brian Owens, [spider-wm022.proxy.aol.com]
Subject: Re: Wiring into a 2 ohm load

URL: my webpage


Here is a good article that goes into more detail than I did. . .

http://www.jlaudio.com/tutorials/dvc/point.html#series

If I had (4) single 4 ohm coil subs, I would wire using series-parallel where you had (2) independent pairs in series, then those (2) sets in parallel to the amp.

Brian


  • View the previous message in this thread
  • Go to the top of this thread
  • View entire thread
    		•

    Posted with TalkShop version 2.73 - BETA

    [Previous Message] [Next Message]



    Follow Ups:

    [ The Subwoofer DIY Page - Discussion Forum ] [ FAQ ]